Notes on Touch Driver Installation under Windows

Concerns MS Operating Systems Windows95, Windows98, NT4, Windows2000, and WindowsXP

Before installing the touch driver, please observe the following hints:

• Make sure that all basic settings are implemented. You can check these as described in FAQ The touchscreen does not react .

• Of great importance is the correct setting of Com ports in BIOS and the verification that the interface in the operating system does exist.

• Please install the current version of the touch driver; this can be downloaded from our download area . (Login required for touch driver download ! )

• Please install the driver first using the standard settings. These should then be modified as follows: Protocol: SC3 serial, Comport: COM4, 9600 baud 8N1

• After installation, you will see a small monitor symbol in the system tray next to the clock. Doubleclick on this to open the properties page of the touch driver where you can set the protocol and the Com parameters.

• If all settings have been checked and correctly set, the touch will react to contact, and the pointer will move accordingly.

• The touch driver has to be calibrated to ensure it works correctly. This can also be done from the properties page of touch driver settings.